Ice dams can cause commercial building roofs to leak and are one of the most typical issues to happen particularly during the winter season as reported by Red Deer gutter cleaning. There are a variety of approaches accessible to fix this problem; nevertheless, the best way is prevention and among the best options in preventing these leaks is heat tape.

Heat tape is, in addition, referred to as “de-icing cables;” they used to melt ice from the region in which they are installed and are warmed by electricity. They run upon the roof top or in gutters to keep a course free for the melted water.

Functionality
It’s imperative that heat tape be properly positioned. Inferior setup of heat tape can lead to even more damage to the structure. Depending on the design, where ice dams typically form, it’s best to be installed. This really is the reason most of these cables are placed along the eaves trough in a zigzag pattern since it creates a channel by which melted water can pass.

Regions including the side walls of a building where snow could be naturally trapped or intersecting roof planes are additional places where heat tape should be installed to help during winter time to minimize ice build-up and prevent leaks. It could be placed immediately, easily and inexpensively compared to what it’d cost to cover repairs brought on by damage from ice dams.

Safety Recommendations
If improperly used, heat tape could take up a fire. Security recommendations supplied by the United States Consumer Product Safety Commission (U.S. CPSC) need to be followed in order to prevent such an occurrence. It’s important to read and carefully follow all the instructions of the maker before installation. Although these safety instructions are generally found on the product carton, below are some other practical tips to follow:

* GFCI Protection – Make sure to just stop up the grounded three-prong unit into a safe electrical outlet which is GFCI (ground-fault circuit interrupter) shielded.

* Cables – Replace the cables when they’re older than three years or when there are signs of overheating including cable discoloration, cracks or any apparent damage.

* Overlapping – If not advocated by producer, de-icing cables should never be placed on top of each other as this could result in overheating and cause a fire.

* End-Cap – Double check to ensure the sealed end-cap is shielded from water escapes to avoid fires in addition to short circuiting.

* Programs – Simply make use of the heat tape for applications approved by producers. There are certain devices that are designed just for conduits and not for use on gutters or roofs.

* Thermostat – If a thermostat is provided with the device, place where positioning is advised for by the directions. For example, a few of these thermostats could be made hanging in the air, but others have to be put away from the snow.

One of many main purposes of heat tape is really to sustain and prolong the life span of a roofing system by helping without causing a fire to remove ice. With proper wisdom and adherence to the security recommendations said previously, heat tapes can ensure that there will be fewer future difficulties with the roof!